Polymaker Shore Filament flexible en TPU à haut débit 1,75 mm Transparent 95 A 1,75 mm Bobine en carton 1 kg - PolyFlex TPU95-HF Filament souple 1,75 mm Filament flexible

〰️ 【Print Fast & UV Resistant TPU Filament】 - PolyFlex TPU95-HF is a Clear flexible filament high flow TPU 1.75 ( high speed TPU filament ) with a shore hardness of 95A and boasts a large strain-to-failure test result with over 400%. Thanks to its high flow ability, it prints incredibly fast. It's also UV resistant which can be used outdoors 【Tangle ************************************************************* & Moisture *************************************************************】 - Polymaker Clear TPU soft filament is carefully winded to avoid any tangling issues, dried and vacuum sealed in a resealable ziplock bag with desiccant. Please make sure to NEVER let go the tip of the filament as it may create nodes. Holes on the side of the spool can be used to prevent this issue 【Flexible & Strong & Consistent & Outstanding Layer Adhesion】 - Super easy to print with. Great flexibility and shape memory. Polymaker 3D filament TPU is strong yet flexible, which has tough rubbery consistency and outstanding layer adhesion, also Bubble-free, Jam ************************************************************* & Warp *************************************************************, easily get really perfect prints with proper settings 【Wide Applications】 - PolyFlex TPU filament 1.75mm ( Clear flexible filament 1.75 )has wide applications including seals, plugs, gaskets, sheets, shoes, key ring case for mobile hands-bike parts shock and wear rubber seal (Wearable Device/Protective applications, such as shoe insoles, watch bands, phone cases, drone parts and more) ️ 【PolyFlex TPU95-HF Printing Settings】 - Nozzle: 200˚C - 220˚C; Bed: 25˚C - 50˚C; Speed: 40mm/s - 100mm/s; Fan: On. Selected Diameter: 3D Printer filament flexible Clear TPU 1.75mm ( Elastic filament Clear TPU Roll ). ️ 【Note】 - PolyFlex TPU Flexible filament 1.75mm should be printed at lower speed than normal. It's better to work on direct drive extruders. Please print slowly and read the tips if you are bowden. Turn off (or limit) retraction if possible.